آمار
| تعداد نشریات | 26 |
| تعداد شمارهها | 447 |
| تعداد مقالات | 4,557 |
| تعداد مشاهده مقاله | 5,380,005 |
| تعداد دریافت فایل اصل مقاله | 3,580,083 |
A Study on Improving the Blades of a Three-Blade Horizontal Axis Wind Turbine for Agricultural Areas Using a Laboratory Made Model | ||
| Biomechanism and Bioenergy Research | ||
| دوره 1، شماره 2، اسفند 2022، صفحه 13-20 اصل مقاله (1014.3 K) | ||
| نوع مقاله: Original Research | ||
| شناسه دیجیتال (DOI): 10.22103/bbr.2022.20362.1016 | ||
| نویسندگان | ||
| Kourosh Ezatollahi* 1؛ Amin Reza Jamshidi1؛ Mehran Riazian2 | ||
| 1Department of Mechanic of Biosystems, Kerman Branch, Islamic Azad University of Kerman, Kerman, Iran | ||
| 2Solid state of physics, Islamic Azad University, Tonekabon Branch, Mazanderan, Iran | ||
| چکیده | ||
| Since Iran is considered a windy country due to its proximity to the sea and the presence of the Alborz and Zagros plateaus. It is necessary to implement mechanisms to increase the production capacity of low-bladed wind turbines. The aim of this study was to determination the optimum parameters of the turbine including: angle of the blade, surface of the conical ratio of the blade and surface of the location of the maximum arc of the chord length. A 3-blade wind turbine was designed and built in a laboratory scale. The thickness of each blade was 20% of the chord length and a thickness of camber was 6% of the chord length. The results showed that the difference between the powers obtained from the experiment at different wind speeds, angles, the location of the maximum arc and the conical ratio of the blade has a significant difference. Results of Duncan's test presented that 15 degrees angle with the average power of 0.8612 W from five levels of blade attack angle, 100% level with the average power of 1.17 W from three levels of the conical ratio of the blade, 30% level with the average power of 0.8139 W from three levels of maximum arc location and 12 m/s with the average power of 1.078 W from three levels of wind speed have the highest productive power. In addition, the interaction of variables (blade attack angle, taper ratio, maximum arc location and speed) is significant and in the model with 15 degrees attack, 100% cone ratio, 30% maximum arc location and 12 m/s wind speed was an optimal model for producing more power. | ||
| کلیدواژهها | ||
| Wind turbine؛ Angle of attack؛ Blade taper ratio؛ Wind speed؛ Power and plane blades | ||
| مراجع | ||
|
Ezatollahi, K, Almasi, M, Borghei, A and Minaei, S (2005). Investigation of the effect of attack angle and blade cone ratio on production power in three-bladed horizontal axis wind turbines with planar blades. Journal of Agriculture Water, Soil and Plant Research in Agriculture, 8, 115-125.
Grassi, S, Chokani, N and Abhari, RS (2012). Large scale technical and economical assessment of wind energy potential with a GIS tool: Case study Iowa. Energy Policy, 45, 73-85.
Howell, R, Qin, N, Edwards, J and Durrani, N (2010). Wind tunnel and numerical study of a small vertical axis wind turbine. Renewable energy, 35, 412-422.
Josimović, B and Pucar, M (2010). The strategic environmental impact assessment of electric wind energy plants: Case study ‘Bavanište’(Serbia). Renewable Energy, 35, 1509-1519.
Krishnamoorthy, R, Udhayakumar, K, Raju, K, Elavarasan, RM and Mihet-Popa, L (2020). An Assessment of Onshore and Offshore Wind Energy Potential in India Using Moth Flame Optimization. Energies, 13, 1-41.
Rasekh, S, Karimian, S and Hosseinidoust, M (2018). Comparison of dynamic stall models using numerical and semi-empirical approaches for a wind-turbine airfoil. Journal of Mechanical Engineering, 18, 282-290.
Satta, F, Tanda, G and Science, F (2014). Measurement of local heat transfer coefficient on the endwall of a turbine blade cascade by liquid crystal thermography. Experimental thermal, 58, 209-215.
Schubel, PJ and Crossley, RJ (2012). Wind turbine blade design. Energies, 5, 3425-3449.
Wen, Q, He, X, Lu, Z, Streiter, R and Otto, T (2021). A comprehensive review of miniatured wind energy harvesters. Nano Materials Science, 3, 170-185.
Xu, Z, Gordon, M, Lind, M and Ostergaard, J. (2009). Towards a Danish power system with 50% wind—Smart grids activities in Denmark. IEEE Power & Energy Society General Meeting. IEEE, 1-8. | ||
|
آمار تعداد مشاهده مقاله: 299 تعداد دریافت فایل اصل مقاله: 169 |
||